IANA Considerations for RADIUS (Remote Authentication Dial In User Service)
Author(s): B. Aboba
This document describes the IANA considerations for the Remote Authentication Dial In User Service (RADIUS). [STANDARDS...
Network Working Group B. Aboba Request for Comments: 3575 Microsoft Updates: 2865 July 2003 Category: Standard Track IANA Considerations for RADIUS (Remote Authentication Dial In User Service) Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2003). All Rights Reserved. Abstract This document describes the IANA considerations for the Remote Authentication Dial In User Service (RADIUS). This document updates RFC 2865. 1. Introduction This document provides guidance to the Internet Assigned Numbers Authority (IANA) regarding registration of values related to the Remote Authentication Dial In User Service (RADIUS), defined in [RFC 2865], in accordance with BCP 26, [RFC 2434]. It also reserves Packet Type Codes that are or have been in use on the Internet. 1.1. Specification of Requirements In this document, several words are used to signify the requirements of the specification. These words are often capitalized. The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC 2119]. Aboba Standards Track [Page 1] RFC 3575 IANA Considerations for RADIUS July 2003 1.2. Terminology The following terms are used here with the meanings defined in BCP 26: "name space", "assigned value", "registration". The following policies are used here with the meanings defined in BCP 26: "Private Use", "First Come First Served", "Expert Review", "Specification Required", "IESG Approval", "IETF Consensus", "Standards Action". 2. IANA Considerations There are three name spaces in RADIUS that require registration: Packet Type Codes, Attribute Types, and Attribute Values (for certain Attributes). This document creates no new IANA registries, since a RADIUS registry was created by [RFC 2865]. RADIUS is not intended as a general-purpose protocol, and allocations SHOULD NOT be made for purposes unrelated to Authentication, Authorization or Accounting. 2.1. Recommended Registration Policies For registration requests where a Designated Expert should be consulted, the responsible IESG area director should appoint the Designated Expert. The intention is that any allocation will be accompanied by a published RFC. However, the Designated Expert can approve allocations once it seems clear that an RFC will be published, allowing for the allocation of values prior to the document being approved for publication as an RFC. The Designated Expert will post a request to the AAA WG mailing list (or a successor designated by the Area Director) for comment and review, including an Internet-Draft. Before a period of 30 days has passed, the Designated Expert will either approve or deny the registration request, publish a notice of the decision to the AAA WG mailing list or its successor, and inform IANA of its decision. A denial notice must be justified by an explanation and, in the cases where it is possible, concrete suggestions on how the request can be modified so as to become acceptable. Packet Type Codes have a range from 1 to 253. RADIUS Type Codes 1-5 and 11-13 were allocated in [RFC 2865], while Type Codes 40-45, 250-253 are allocated by this document. Type Codes 250-253 are allocated for Experimental Uses, and 254-255 are reserved. Packet Type Codes 6-10, 12-13, 21-34, 50-51 have no meaning defined by an IETF RFC, but are reserved until a specification is provided for them. This is being done to avoid interoperability problems with software that implements non-standard RADIUS extensions that are or Aboba Standards Track [Page 2] RFC 3575 IANA Considerations for RADIUS July 2003 have been in use on the Internet. Because a new Packet Type has considerable impact on interoperability, a new Packet Type Code requires IESG Approval. The intention is that any allocation will be accompanied by a published RFC. Type Codes 52-249 should be allocated first; when these are exhausted, Type Codes 14-20, 35-39, 46-49 may be allocated. For a list of Type Codes, see Appendix A. Attribute Types have a range from 1 to 255, and are the scarcest resource in RADIUS, thus must be allocated with care. Attributes 1-53,55,60-88,90-91,94-100 have been allocated, with 17 and 21 available for re-use. Attributes 17, 21, 54, 56-59, 89, 101-191 may be allocated by IETF Consensus. It is recommended that attributes 17 and 21 be used only after all others are exhausted. Note that RADIUS defines a mechanism for Vendor-Specific extensions (Attribute 26) for functions specific only to one vendor's implementation of RADIUS, where no interoperability is deemed useful. For functions specific only to one vendor's implementation of RADIUS, the use of that should be encouraged instead of the allocation of global attribute types. As noted in [RFC 2865]: Attribute Type Values 192-223 are reserved for experimental use, values 224-240 are reserved for implementation-specific use, and values 241-255 are reserved and should not be used. Therefore Attribute Type values 192-240 are considered Private Use, and values 241-255 require Standards Action. Certain attributes (for example, NAS-Port-Type) in RADIUS define a list of values to correspond with various meanings. There can be 4 billion (2^32) values for each attribute. Additional values can be allocated by the Designated Expert. The exception to this policy is the Service-Type attribute (6), whose values define new modes of operation for RADIUS. Values 1-16 of the Service-Type attribute have been allocated. Allocation of new Service-Type values are by IETF Consensus. The intention is that any allocation will be accompanied by a published RFC. 3. References 3.1. Normative References [RFC 2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. Aboba Standards Track [Page 3] RFC 3575 IANA Considerations for RADIUS July 2003 [RFC 2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an IANA Considerations Section in RFCs", BCP 26, RFC 2434, October 1998. [RFC 2865] Rigney, C., Willens, S., Rubens, A. and W. Simpson, "Remote Authentication Dial In User Service (RADIUS)", RFC 2865, June 2000. 3.2. Informative References [RFC 2607] Aboba, B. and J. Vollbrecht, "Proxy Chaining and Policy Implementation in Roaming", RFC 2607, June 1999. [RFC 2866] Rigney, C., "RADIUS Accounting", RFC 2866, June 2000. [RFC 2867] Zorn, G., Aboba, B. and D. Mitton, "RADIUS Accounting Modifications for Tunnel Protocol Support", RFC 2867, June 2000. [RFC 2868] Zorn, G., Leifer, D., Rubens, A., Shriver, J., Holdrege, M. and I. Goyret, "RADIUS Attributes for Tunnel Protocol Support", RFC 2868, June 2000. [RFC 2869] Rigney, C., Willats, W. and P. Calhoun, "RADIUS Extensions", RFC 2869, June 2000. [RFC 2869bis] Aboba, B. and P. Calhoun, "RADIUS Support for Extensible Authentication Protocol (EAP)", Work in Progress. [RFC 2882] Mitton, D., "Network Access Servers Requirements: Extended RADIUS Practices", RFC 2882, July 2000. [RFC3162] Aboba, B., Zorn, G. and D. Mitton, "RADIUS and IPv6", RFC3162, August 2001. [DynAuth] Chiba, M., Dommety, G., Eklund, M., Mitton, D. and B. Aboba, "Dynamic Authorization Extensions to Remote Authentication Dial In User Service (RADIUS)", RFC 3576, July 2003. 4. Security Considerations The security considerations detailed in [RFC 2434] are generally applicable to this document. Security considerations relating to the RADIUS protocol are discussed in [RFC 2607], [RFC 2865], [RFC3162], [DynAuth], and [RFC 2869bis]. Aboba Standards Track [Page 4] RFC 3575 IANA Considerations for RADIUS July 2003 Appendix A - RADIUS Packet Types A list of RADIUS Packet Type Codes is given below. This document instructs IANA to list them in the registry of Packet Type Codes. Note that Type Codes 40-45, defined in [DynAuth], are being formally allocated here. Codes 40-45 were listed in [RFC 2882] and have been implemented and used. Given their current widespread usage, these assignments are not reclaimable in practice. # Message Reference ---- ------------------------- --------- 1 Access-Request [RFC 2865] 2 Access-Accept [RFC 2865] 3 Access-Reject [RFC 2865] 4 Accounting-Request [RFC 2865] 5 Accounting-Response [RFC 2865] 6 Accounting-Status [RFC 2882] (now Interim Accounting) 7 Password-Request [RFC 2882] 8 Password-Ack [RFC 2882] 9 Password-Reject [RFC 2882] 10 Accounting-Message [RFC 2882] 11 Access-Challenge [RFC 2865] 12 Status-Server (experimental) [RFC 2865] 13 Status-Client (experimental) [RFC 2865] 21 Resource-Free-Request [RFC 2882] 22 Resource-Free-Response [RFC 2882] 23 Resource-Query-Request [RFC 2882] 24 Resource-Query-Response [RFC 2882] 25 Alternate-Resource- Reclaim-Request [RFC 2882] 26 NAS-Reboot-Request [RFC 2882] 27 NAS-Reboot-Response [RFC 2882] 28 Reserved 29 Next-Passcode [RFC 2882] Aboba Standards Track [Page 5] RFC 3575 IANA Considerations for RADIUS July 2003 # Message Reference ---- ------------------------- --------- 30 New-Pin [RFC 2882] 31 Terminate-Session [RFC 2882] 32 Password-Expired [RFC 2882] 33 Event-Request [RFC 2882] 34 Event-Response [RFC 2882] 40 Disconnect-Request [DynAuth] 41 Disconnect-ACK [DynAuth] 42 Disconnect-NAK [DynAuth] 43 CoA-Request [DynAuth] 44 CoA-ACK [DynAuth] 45 CoA-NAK [DynAuth] 50 IP-Address-Allocate [RFC 2882] 51 IP-Address-Release [RFC 2882] 250-253 Experimental Use 254 Reserved 255 Reserved [RFC 2865] Aboba Standards Track [Page 6] RFC 3575 IANA Considerations for RADIUS July 2003 Intellectual Property Statement The IETF takes no position regarding the validity or scope of any intellectual property or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; neither does it represent that it has made any effort to identify any such rights. Information on the IETF's procedures with respect to rights in standards-track and standards- related documentation can be found in BCP-11. Copies of claims of rights made available for publication and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF Secretariat. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights which may cover technology that may be required to practice this standard. Please address the information to the IETF Executive Director. Acknowledgments Thanks to Ignacio Goyret of Lucent, Allison Mankin of Lucent Bell Labs, Thomas Narten of IBM, Glen Zorn and Harald Alvestrand of Cisco for discussions relating to this document. Authors' Addresses Bernard Aboba Microsoft Corporation One Microsoft Way Redmond, WA 98052 EMail: firstname.lastname@example.org Phone: +1 425 706 6605 Fax: +1 425 936 7329 Aboba Standards Track [Page 7] RFC 3575 IANA Considerations for RADIUS July 2003 Full Copyright Statement Copyright (C) The Internet Society (2003). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assignees. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Aboba Standards Track [Page 8]