DHCP Option for The Open Group's User Authentication Protocol
Author(s): S. Drach
This document defines a DHCP option that contains a list of pointers to User Authentication Protocol servers that provide user authentication services for clients that conform to The Open Group Network Computing Client Technical Standard....
Network Working Group S. Drach Request for Comments: 2485 Sun Microsystems Category: Standards Track January 1999 DHCP Option for The Open Group's User Authentication Protocol Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (1999). All Rights Reserved. Abstract This document defines a DHCP  option that contains a list of pointers to User Authentication Protocol servers that provide user authentication services for clients that conform to The Open Group Network Computing Client Technical Standard . Introduction The Open Group Network Computing Client Technical Standard, a product of The Open Group's Network Computing Working Group (NCWG), defines a network computing client user authentication facility named the User Authentication Protocol (UAP). UAP provides two levels of authentication, basic and secure. Basic authentication uses the Basic Authentication mechanism defined in the HTTP 1.1  specification. Secure authentication is simply basic authentication encapsulated in an SSLv3  session. In both cases, a UAP client needs to obtain the IP address and port of the UAP service. Additional path information may be required, depending on the implementation of the service. A URL  is an excellent mechanism for encapsulation of this information since many UAP servers will be implemented as components within legacy HTTP/SSL servers. Drach Standards Track [Page 1] RFC 2485 DCHP Option for the Open Group's UAP January 1999 Most UAP clients have no local state and are configured when booted through DHCP. No existing DHCP option  has a data field that contains a URL. Option 72 contains a list of IP addresses for WWW servers, but it is not adequate since a port and/or path can not be specified. Hence there is a need for an option that contains a list of URLs. User Authentication Protocol Option This option specifies a list of URLs, each pointing to a user authentication service that is capable of processing authentication requests encapsulated in the User Authentication Protocol (UAP). UAP servers can accept either HTTP 1.1 or SSLv3 connections. If the list includes a URL that does not contain a port component, the normal default port is assumed (i.e., port 80 for http and port 443 for https). If the list includes a URL that does not contain a path component, the path /uap is assumed. 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Code | Length | URL list +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Code 98 Length The length of the data field (i.e., URL list) in bytes. URL list A list of one or more URLs separated by the ASCII space character (0x20). References  Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, March 1997.  Technical Standard: Network Computing Client, The Open Group, Document Number C801, October 1998.  Fielding, R., Gettys, J., Mogul, J., Frystyk, H., and T. Berners-Lee, "Hypertext Transfer Protocol -- HTTP/1.1", RFC 2068, January 1997.  Freier, A., Karlton, P., and P. Kocher, "The SSL Protocol, Version 3.0", Netscape Communications Corp., November 1996. Standards Information Base, The Open Group, http://www.db.opengroup.org/sib.htm#SSL_3. Drach Standards Track [Page 2] RFC 2485 DCHP Option for the Open Group's UAP January 1999  Berners-Lee, T., Masinter, L., and M. McCahill, "Uniform Resource Locators (URL)", RFC 1738, December 1994.  Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor Extensions", RFC 2132, March 1997. Security Considerations DHCP currently provides no authentication or security mechanisms. Potential exposures to attack are discussed in section 7 of the DHCP protocol specification. The User Authentication Protocol does not have a means to detect whether or not the client is communicating with a rogue authentication service that the client contacted because it received a forged or otherwise compromised UAP option from a DHCP service whose security was compromised. Even secure authentication does not provide relief from this type of attack. This security exposure is mitigated by the environmental assumptions documented in the Network Computing Client Technical Standard. Author's Address Steve Drach Sun Microsystems, Inc. 901 San Antonio Road Palo Alto, CA 94303 Phone: (650) 960-1300 EMail: email@example.com Drach Standards Track [Page 3] RFC 2485 DCHP Option for the Open Group's UAP January 1999 Full Copyright Statement Copyright (C) The Internet Society (1999). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Drach Standards Track [Page 4]